Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Topics pertaining to SRM usage, usability and management.
- Threads: 351
- Messages: 2,557
Filter by prefix:
Seeing that I will be tightening up the firewall here, have a question on firewall rules.
Say I put a small unmanaged switch on LAN 2, LAN3 and...
Afternoon all.
A couple of weeks ago I ditched my Draytek for a synology router. Main reason being ease of use.
Set up was straightforward in...
All.
One minute I can see where to post then I look away and its gone (ok down off the page under suggestions :-) Ho Hum..
Right.... I have an...
Synology has specific steps on how to "block access between two local networks while allowing communication among certain devices" (How can I...
Hi,
I would like to start off a discussion about firewall best practices with the router. Here is my current configuration and what it does.
1...
Hey,
I been using Synology RT6600ax last few months and it works great for me :)
I just noticed one firewall rule "allow from lan" can't be...
- Question
2600 Router, SRM 1.3.1
When I turn off or disable the router's Firewall, the Malicious Events drop by 26X! Why?
This investigation started when...
I’ve been using this for the firewall rules of what’s legal or not to make a firewall rule...
Crazy idea: Is it possible (legal) that a firewall rule like this could exist and work?
TCP/UDP, all ports, IP RANGE:192.168.1.160-.255, TCP/UDP...
- Question
I had blocked all countries except U.S. thinking it would reduce the Threat Protection noise
and the Malicious Events daily count dropped from...
I've 13 Hikvision Cameras that have the latest firmware in them, but firmware pre-dates Last September's Hikvision Security issues.... I do not...
- Question
Ok, I thought I finally had things set up securely but now firewall isn’t blocking properly. Using SRM 1.2.5 (This post ties to @rkruz3 do...
I have setup the router's (2600, V1.2.5) firewall to block entire subnets, e.g. 2.0.0.0 - 2.255.255.255, yet threat IP addresses within this...
This is more SRM 1.3.1-1 than RT2600ac specific.
Something has been bugging me:
I use IPV4 settings here.
In SRM settings, I have disabled IPV6...
If the Firewall has a rule to block an entire IP range, say 45.0.0.1/255.0.0.0, will Threat Prevention still react to threat IP in that range or...
Hey,
those 2 firewall rules are those needed ?
And in what situation are those 2 needed ?
thx
Should a firewall rule: denying ICMP(ping) to the IP your ISP assigned you — your router, work, and log hits?
Thank you
- Question
RT2600ac
Seeing that both Router and ISP have had changes recently.... I'm not exactly sure... but I suspect it's the ISP
I had an ICMP Allow...
- Solved
questions....
The top rule in my firewall is a rule where a rage of IP's are ALLOWED access to internet: Soruce IP Range, All SOURCE PORTS, ALL...
In a month or so, I will need to increase the amount of ICMP (For Pinging) Router firewall "ALLOW" Rules from 1 (Which is working fine now) to...
Create an account or login to comment
You must be a member in order to leave a comment
Create account
Create an account on our community. It's easy!
Log in
Already have an account? Log in here.