Can't get a link on Eth 2-4 on RS2414rp+

Currently reading
Can't get a link on Eth 2-4 on RS2414rp+

I am unable to get a link on Eth 2 - 4 on RS2414rp+. I have tried different cables, used SSH to down/up the port(s) and plugged the Syno Eth2 into another switch just to see if link would come up. I am assuming networking on the port does not matter, it should still get a link.
 

Create an account or login to comment

You must be a member in order to leave a comment

Create account

Create an account on our community. It's easy!

Log in

Already have an account? Log in here.

Old thread notice: There have been no replies in this thread for quite some time. The last reply was on .
The content in this thread may no longer be relevant. It might be better to open a new thread instead.

Similar threads

That is about the GB Ethernet maximum speed. 984/ 8 = about 120MB/s relatively high, not an average.
Replies
1
Views
686
Please bare in mind that this approach will not allow to issue letsencrypt wilcard certificates for your...
Replies
6
Views
4,694
If this is a one-time deal, it might be a good idea to do this through Resilio Sync instead.
Replies
11
Views
1,385
Use your local nas ip and the port that you have for the server. Configure after that your server via...
Replies
104
Views
21,804
If you could get the var/log/messages file out for review that would help to understand what is going on...
Replies
1
Views
1,240

Welcome to SynoForum.com!

SynoForum.com is an unofficial Synology forum for NAS owners and enthusiasts.

Registration is free, easy and fast!

Trending threads

Back
Top