DSM Update DSM Version Version: 6.2.4-25556 Update 2 Released

[fredbert]

Yep. Not the first time they did that.

It’s at least the third or fourth, maybe even fifth, first time that this has happened.

 

[Telos]

It’s at least the third or fourth, maybe even fifth, first time that this has happened.

It's an honor culture thing. Never admit mistakes. Bury them or whitewash them over. Must save face.

 

[vallieres]

It's an honor culture thing. Never admit mistakes. Bury them or whitewash them over. Must save face.

So, my NAS updated early this morning and I can't load the DSM nor can I SSH into it. Synology Assistant reports 6.2.4-25556 update 2 as the version it currently runs.

Chances are it downloaded the first, bad, update and just waited to install it?
How can I fix this? Reset network settings + admin (4 sec reset button) ?

Or do I have to go through the full reinstall of DSM?

 

[Rusty]

So, my NAS updated early this morning and I can't load the DSM nor can I SSH into it. Synology Assistant reports 6.2.4-25556 update 2 as the version it currently runs.

Chances are it downloaded the first, bad, update and just waited to install it?
How can I fix this? Reset network settings + admin (4 sec reset button) ?

Or do I have to go through the full reinstall of DSM?

Can you ping the device at all?

 

[vallieres]

It is very weird. I could never reach the NAS in a browser (many browsers) on both HTTP and HTTP port. Then I tried SSH, still not working. Basically left it like that and the next day for some reason I could load up DSM normally... But SSH still does not work even if I can clearly see it enabled with the right port....

-- post merged: 17. Sep 2021 --

Also, I removed the NAS config for static IPs and set that in my Eeero.

 

[Telos]

But SSH still does not work even if I can clearly see it enabled with the right port....

I was going to respond here, however this conversation has drifted off topic, and should probably be reopened in a new thread.