Hi Folks,
I am replacing my old DS214play with a DS218+. I have about 1.8TB of data on the old box, mostly music, photos and PC backups. Both boxes are on the same switch on my home network.
The only migration method available is Hyperbackup, which I set off over 24 hours ago and it started well but eventually ground to a halt at around 70% complete. If I hover over the task, the pop up says 0Mb/s.
I’ve tried suspending and restarting a couple of times and that seems to kick it into life for a while. I’ve just done another suspend/restore and it’s now up to around 80% but running at under 3Mb/s - that seems inordinately slow. Is this normal?
I’m wondering about either abandoning the full backup and trying to do it in chunks (assuming that’s feasible) or just mounting the old DS folders on the new DS and doing a drag and drop - also in manageable chunks.
Has anyone any advice for me? I’d be grateful.
I am replacing my old DS214play with a DS218+. I have about 1.8TB of data on the old box, mostly music, photos and PC backups. Both boxes are on the same switch on my home network.
The only migration method available is Hyperbackup, which I set off over 24 hours ago and it started well but eventually ground to a halt at around 70% complete. If I hover over the task, the pop up says 0Mb/s.
I’ve tried suspending and restarting a couple of times and that seems to kick it into life for a while. I’ve just done another suspend/restore and it’s now up to around 80% but running at under 3Mb/s - that seems inordinately slow. Is this normal?
I’m wondering about either abandoning the full backup and trying to do it in chunks (assuming that’s feasible) or just mounting the old DS folders on the new DS and doing a drag and drop - also in manageable chunks.
Has anyone any advice for me? I’d be grateful.