Hi,
I've found some helpfull information on this forum (thanks a lot for sharing them) and tried to rebuild the bios of my DS412+.
I desoldered the chip and read it with an EZ2023+ programmer.
The backup shows 1st part of the chip (till 2Mb) with some information (some part were blank 0xFF...
Hi,
I'm trying to get a DS2413+ revived (blinking blue light, no beep), the power are good, the DOM is clean and seems healthy (6Mb/s)
The battery cell is ok (3v for CR2032)
So I suspect the bios but before desoldering the chip i was trying to listen to the boot thru the console and I could...
Hello,
my Synology NAS DS216play is faulty: the blue LED keeps blinking endlessly. I have tried all reset procedures, with no improvement.
Using the serial port, I don’t see any readable characters (the connection is OK, tested on another NAS). I have tested several power supplies, same result...
Hello everyone!
I have a parallel post where I describe my issue with a Synology DS918+, which only boots after being powered off for a while. You can check out the details here: DS918+ Boots Only When Cold.
During my troubleshooting process, I had to flash the Winbond BIOS chip with the...
Hello everyone!
I recently bought a used Synology 918+ online. It came without a power brick, no memory, and—worst of all—no guarantee that it even worked.
At first glance, it looked brand new: clean fans, no scratches, no visible damage. So, I took the risk and ordered a 4GB Synology memory...